AUTOMATIC STAIR CASE WHITE LED CONTROLLER

QBITSTRV2 controller is used for dynamic color (white) lighting of the stairs.

The backlight is switched on with the controller subsequent steps, depending on the motion directions: ascending or descending and 4 steps by 4 steps also

QBITSTRV2 controller is used for dynamic color (white) lighting of the stairs.

The backlight is switched on with the controller subsequent steps, depending on the motion directions: ascending or descending and 4 steps by 4 steps also

The controller is adapted to control the WHITE LED strips arranged in stair steps and possibly the staircase handrails.

The controller has two programs of pattern changing: in the first program each stage is lit with a different color; in second program color at all steps is the same, but changes smoothly when the steps are turned on, lights on and off. Will change to another 4 steps at every turning on the light of the stairs

STAIRCASE LED LIGHTS CONTROLLER – WHITE SINGLE COLOR- OUTPUT 24 STEPS-12V/2A- LOW POWER- MODEL-QBITSTRV1.0

This control unit enables the sensor-controlled switching on and o of your LED stair lighting. The effect can be easily adjusted via rotary control on the device top. An external continuous light switch as well

as a two light sensor can be connected to the control unit and thus round o the functional spectrum.

Thanks to the modular design of the control unit, the range of functions can also be expanded easily and cost-effectively.

Technical data:

  • Power supply – 12V stabilized (external)
  • Maximum electric current of LEDs at one step support – 12V/30A
  • Max. Steps : 1 to 24
    The LED on the case – signaling operation.
  • Dimensions: length – 150 mm (6 in), width – 90 mm (3.5 in), height – 67 mm (2.6 in).
  • Toggle switch-UP : pattern 1-one by one led will glow
  • Toggle switch-DOWN : pattern 2-Four by four led will glow: Power save mode

Connecting the sensors:

  • The bottom step sensor (LED- channel 1) should be wired to connection SENSOR 1, and the top step to     SENSOR 2.

    The colored markings of the supplied sensor cable must be connected to the control unit as well as to the

    PIR sensor connection adapter as follows:

    • Red = + (Power supply – 5V)
    • brown = Signal PIR
    • Black = – (Earth/GND)

 

  • Download Manual: 

Demo V1 & v2 – Link: https://www.youtube.com/watch?v=yE0eMY2k-ns

Skip to toolbar